2014 Hilux · Service Manual SECURITIES

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Aug 2012 – Jul 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

HINT:
  1. Use these procedures to troubleshoot the engine immobiliser system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      1. If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.CRANK ENGINE FOR MORE THAN 10 SECONDS
      NEXT

      4.CHECK FOR DTC*
      1. Check for DTCs and note any codes that are output (Click here).

      2. Based on the DTCs output above, proceed to each diagnostic procedure.

        Result 
        Result
        Proceed to
        DTC is not output
        A
        SFI system (for 1TR-FE) DTC is output
        B
        SFI system (for 2TR-FE) DTC is output
        C
        SFI system (for 1GR-FE) DTC is output
        D
        ECD system (for 1KD-FTV [for DPF]) DTC is output
        E
        ECD system (for 1KD-FTV [w/ EGR Cooler]) DTC is output
        F
        ECD system (for 1KD-FTV [w/o EGR Cooler]) DTC is output
        G
        ECD system (for 2KD-FTV [for DPF]) DTC is output
        H
        ECD system (for 2KD-FTV [w/ EGR Cooler]) DTC is output
        I
        ECD system (for 2KD-FTV [w/o EGR Cooler]) DTC is output
        J
        Engine immobiliser system DTC is output
        K


      B.

      C.

      D.

      E.

      F.

      G.

      H.

      I.

      J.

      K.
      A

      5.PROBLEM SYMPTOMS TABLE
      1. Refer to Problem Symptoms Table (Click here).

        Result 
        Result
        Proceed to
        Fault is not listed in problem symptoms table
        A
        Fault is listed in problem symptoms table
        B


      B.
      A

      6.OVERALL ANALYSIS AND TROUBLESHOOTING*
      1. Data List/Active Test (Click here).

      2. Terminals of ECU (Click here).

      NEXT

      7.ADJUST, REPAIR OR REPLACE
        NEXT

        8.CHECK FOR DTC*
        1. Clear the DTCs (Click here).

        2. Check for DTCs (Click here).

          HINT:
          Before checking for DTCs, perform the "DTC Output Confirmation Operation" of each diagnostic procedure (Click here).

          Result 
          Result
          Proceed to
          DTC is not output
          A
          Engine immobiliser system DTC is output
          B


        B.
        A

        9.CONFIRMATION TEST
          NEXT

          ← HOW TO PROCEED WITH TROUBLESHOOTING (Jun 2011 – Jul 2012)HOW TO PROCEED WITH TROUBLESHOOTING (from Aug 2013) →