2014 Hilux · Service Manual SECURITIES

DIAGNOSTIC TROUBLE CODE CHART

Diagnostic trouble codes · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

HINT:
If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below.

Transponder Key ECU Assembly 
DTC Code
Detection Item
Detection Enabling Condition (DTC Output Confirmation Operation)
See page
B2780
Push Switch / Key Unlock Warning Switch Malfunction
Insert the key into the ignition key cylinder.
Click here
B2784
Antenna Coil Open / Short
Insert the key into the ignition key cylinder.
Click here
B2793
Transponder Chip Malfunction
Insert the key into the ignition key cylinder.
Click here
B2794
Unmatched Encryption Code
Insert the key into the ignition key cylinder.
Click here
B2795
Unmatched Key Code
Insert the key into the ignition key cylinder.
Click here
B2796
No Communication in Immobiliser System
Insert the key into the ignition key cylinder.
Click here
B2797
Communication Malfunction No. 1
Insert the key into the ignition key cylinder.
Click here
B2798
Communication Malfunction No. 2
Insert the key into the ignition key cylinder.
Click here
ECM 
DTC Code
Detection Item
Detection Enabling Condition (DTC Output Confirmation Operation)
See page
B2799
Engine Immobiliser System Malfunction
Either condition is met:
- Within 10 seconds of an engine start operation being performed (with the shift lever in P and the brake pedal*1 or clutch pedal*2 depressed, turn the ignition switch to ON). If there is a malfunction, the engine stops (communication begins within 3 seconds of the engine start operation being performed, and DTCs are stored after 6 seconds).
- 10 seconds after the ignition switch is turned to ON after reconnecting the cable to the negative (-) battery terminal (communication begins within 3 seconds of the ignition switch being turned to ON, and DTCs are stored after 6 seconds).
Click here
B279A*3
Theft Deterrent System Communication Line High Fixation
Turn the ignition switch to ON and wait 6 seconds.
Click here
B279C*3
Theft Deterrent System Presence Detection
Check for DTCs.
Click here
  1. *1: for Automatic Transmission
  2. *2: for Manual Transmission
  3. *3: except 1TR-FE, 2TR-FE
← DATA LIST / ACTIVE TEST (from Jun 2011)DIAGNOSTIC TROUBLE CODE CHART (Aug 2012 – Jul 2013) →