2014 Hilux · Service Manual SECURITIES

B279C Theft Deterrent System Presence Detection

Diagnostic trouble codes · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

DESCRIPTION

If an ECM that is incompatible with the engine immobiliser system is installed, the ECM stores this DTC.
DTC Code
DTC Detection Condition
Trouble Area
DTC Output Confirmation Operation
B279C
An ECM that is incompatible with the engine immobiliser system is installed (1 trip detection logic*).
ECM
Check for DTCs.
  1. *: Only output while a malfunction is present.
Vehicle Condition and Fail-safe Operation when Malfunction Detected 
Vehicle Condition when Malfunction Detected
Fail-safe Operation when Malfunction Detected
Engine cannot be started.
-
Related Data List and Active Test 
DTC Code
Data List and Active Test
B279C
-

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the ECM, refer to the Service Bulletin.
  2. After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.


1. REPLACE CURRENT ECM WITH PROPER ECM
  1. Replace the current ECM with the proper ECM.

    1. for 1KD-FTV (except DPF): Click here
    2. for 1KD-FTV (for DPF): Click here
    3. for 2KD-FTV (except DPF): Click here
    4. for 2KD-FTV (for DPF): Click here
    5. for 1GR-FE: Click here


NEXT

END


← B279A Theft Deterrent System Communication Line High Fixation (from Aug 2013)B279C Theft Deterrent System Presence Detection (Aug 2012 – Jul 2013) →