2014 Hilux · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built from Jun 2011

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. REMOVE FRONT WHEEL

2. REMOVE FRONT SPEED SENSOR LH

C113712
  1. Remove the bolt and disconnect the speed sensor.

  1. Remove the 3 bolts and disconnect the 3 clamps.


3. REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH

F049868E01
  1. Remove the union bolt and disconnect the brake hose from the brake cylinder.

  1. Remove the 2 bolts and brake cylinder.


4. REMOVE FRONT DISC

5. DISCONNECT TIE ROD END SUB-ASSEMBLY

F049764E01
  1. Remove the cotter pin and nut.

  1. Using SST, disconnect the tie rod end from the steering knuckle.

    SST
    09628-62011  


6. DISCONNECT FRONT SUSPENSION LOWER ARM ASSEMBLY WITH ATTACHMENT LH

F049765E01
  1. Remove the 2 bolts and disconnect the suspension arm from the steering knuckle.


7. DISCONNECT FRONT SUSPENSION UPPER ARM ASSEMBLY LH

F049766E01
  1. Remove the clip and nut.

  1. Using SST, disconnect the steering knuckle from the suspension upper arm.

    SST
    09628-62011  


8. REMOVE FRONT AXLE HUB ASSEMBLY

9. REMOVE KNUCKLE GREASE RETAINER CAP

F049767E01
  1. Using a screwdriver and hammer, tap out the knuckle grease retainer cap.


10. REMOVE FRONT AXLE HUB NUT AND ABS SPEED SENSOR ROTOR OR SPACER

F049768E01
  1. Using a chisel and hammer, loosen the staked part of the lock nut.

  1. F049769E01
    Remove the lock nut.

  1. w/ ABS:
    Remove the ABS speed sensor rotor.

    NOTICE:
    Take care not to scratch the serration of the speed sensor rotor.

  1. w/o ABS:
    Remove the spacer.


11. REMOVE STEERING KNUCKLE

F049860E01
  1. Remove the 3 bolts, and shift the dust cover towards the hub side (outside).

  1. Using SST, remove the steering knuckle.

    SST
    09710-30021   (09710-03051)
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04031, 09957-04010, 09958-04011)

  1. Remove the dust cover from the axle hub.

    NOTICE:
    Take care not to scratch the serration of the speed sensor rotor.


12. REMOVE FRONT AXLE HUB OIL SEAL
  1. Using a screwdriver, pry out the oil seal from the steering knuckle.


13. REMOVE FRONT AXLE HUB INNER BEARING

F049861E01
  1. Using snap ring pliers, remove the snap ring.

  1. Using SST and a press, press out the bearing from the steering knuckle.

    SST
    09950-60020   (09951-00810)
    09950-70010   (09951-07150)

← ON-VEHICLE INSPECTION (from Jun 2011)INSTALLATION (from Jun 2011) →