ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jun 2011
| CHECK FRONT AXLE HUB BEARING |
![]() ![]() |
Remove the front wheel.
TSAM made:
Remove the front disc brake cylinder (Click here).
TMT made:
Remove the front disc brake cylinder (Click here).
Remove the front disc.
Inspect the axle hub backlash.
Using a dial indicator, check the backlash near the center of the axle hub.
- Maximum backlash:
- 0.05 mm (0.0020 in.)
Inspect the axle hub deviation.

Using a dial indicator, check the deviation on the surface of the axle hub.
- Maximum deviation:
- 0.05 mm (0.0020 in.)

