DTC CHECK / CLEAR
Troubleshooting · Vehicles built Jun 2011 – Jul 2013
Versions by build date: Jun 2011 – Jul 2013 from Aug 2013
| CHECK DTC (When not using intelligent tester:) |
![]() ![]() |
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
- SST
- 09843-18040
Turn the ignition switch ON.
Read the DTC from the ABS warning light on the combination meter.
- HINT:
- If no code appears, check the TC circuit or ABS warning light circuit.
Trouble Area
See procedure
TC and CG terminal circuit
Click here
ABS warning light circuit
Click here
- If more than 1 DTC is detected at the same time, the DTCs will be displayed in numerical order.
-
As an example, the blinking patterns for a normal system code and DTCs 11 and 21 are shown in the illustration.

- DTCs are explained in the Diagnostic Trouble Code Chart.
- If no code appears, check the TC circuit or ABS warning light circuit.
After completing the check, disconnect terminals 13 (TC) and 4 (CG) of the DLC3, and turn off the display.
| CHECK DTC (When using intelligent tester:) |
![]() ![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Read the DTCs by following the prompts on the tester screen.
- HINT:
- Refer to the intelligent tester operator's manual for further details.
| CLEAR DTC (When not using intelligent tester:) |
![]() ![]() |
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
- SST
- 09843-18040
Turn the ignition switch ON.
Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.

Check that the ABS warning light displays the normal system code.
Remove SST from the terminals of the DLC3.
- HINT:
- DTCs cannot be cleared by removing the battery cable or ECU-IG and GAUGE fuse.
| CLEAR DTC (When using intelligent tester:) |
![]() ![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Operate the intelligent tester to erase the codes.
- HINT:
- Refer to the intelligent tester operator's manual for further details.
| CHECK ABS WARNING LIGHT |
Turn the ignition switch ON.
Check that the ABS warning light illuminates and then turns off in approximately 3 seconds.


