REMOVAL
Removal / installation · Vehicles built Aug 2012 – Jul 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 2. REMOVE REAR WHEEL |
| 3. REMOVE REAR SPEED SENSOR |
Disconnect the sensor connector.


Detach the clamp.
Remove the 2 bolts and 2 harness clamps.
Remove the bolt and speed sensor LH.
Disconnect the sensor connector.


Detach the connector.
Detach the 2 clamps.
Remove the bolt and harness clamp.
Remove the bolt and speed sensor RH.
