REMOVAL
Removal / installation · Vehicles built Aug 2012 – Jul 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 2. DRAIN BRAKE FLUID |
- NOTICE:
- Wash off brake fluid immediately if it comes in contact with any painted surface.
| 3. REMOVE BRAKE ACTUATOR ASSEMBLY WITH BRACKET |
Place tags or marks to identify the installation locations of each brake line.


Release the latch of the actuator connector and disconnect the connector.
Using a union nut wrench, disconnect the 5 brake lines from the actuator.


for LHD:

Remove the 3 bolts and actuator with bracket.- NOTICE:
- Be careful not to damage the brake tubes.
for RHD:

Remove the 3 nuts and actuator with bracket.- NOTICE:
- Be careful not to damage the brake tubes.
