REMOVAL
Removal / installation · Vehicles built from Jun 2011
| 1. REMOVE NO. 1 ENGINE UNDER COVER |
| 2. REMOVE NO. 2 ENGINE UNDER COVER |
| 3. DRAIN DIFFERENTIAL OIL |
for front differential:
Stop the vehicle on a level surface.
Using SST and the 10 mm straight hexagon wrench, 10 mm union nut wrench and socket adaptor, remove the differential filler plug and gasket.

- SST
- 09961-00950
Text in Illustration *1
10 mm Straight Hexagon Wrench
*2
10 mm Union Nut Wrench
*3
Socket Adaptor
Remove the drain plug and gasket, and drain the oil.
Install a new gasket and the drain plug.
- Torque:
- 65 N*m{ 660 kgf*cm , 48 ft.*lbf }
for rear differential:
Stop the vehicle on a level surface.
Remove the differential filler plug and gasket.
Remove the drain plug and gasket, and drain the oil.
Install a new gasket and the drain plug.
- Torque:
- 49 N*m{ 500 kgf*cm , 36 ft.*lbf }
| 4. REMOVE FRONT PROPELLER SHAFT ASSEMBLY |
for TSAM Made:
(Click here)
for TMT Made:
(Click here)
| 5. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH |
| 6. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH |
- HINT:
- Use the same procedure described for the LH side.
| 7. REMOVE FRONT DIFFERENTIAL CARRIER ASSEMBLY |
Remove the bolt and disconnect the differential breather tube bracket.
Support the differential with a jack.
Remove the No. 1 differential mounting nut.

Text in Illustration *1
Mounting Bolt
*2
Mounting Nut
Remove the 2 mounting bolts and 2 nuts.
Lower the jack and remove the front differential.
Remove the 3 bolts and front No. 1 differential support.

Remove the 2 mount stoppers from the differential support.
Remove the 2 bolts and front No. 2 differential support.

Remove the 2 bolts and front No. 3 differential support.

