REMOVAL
Removal / installation · Vehicles built from Jun 2011
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE FRONT EXHAUST PIPE ASSEMBLY (for DPF) |
| 3. DISCONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR |
| 4. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
![]() ![]() |
Using a screwdriver, bend the tabs of the lock washer.
Remove the lock nut and lock washer.
Remove the bolt and park/neutral position switch.
- HINT:
- Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft.


