INSPECTION
Inspection · Vehicles built from Jun 2011
| INSPECT FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH |
![]() ![]() |
As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut.
Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the fifth turn.
- Turning torque:
- 0.29 to 4.5 N*m (3 to 46 kgf*cm, 3 to 40 in.*lbf) or less
Check for any cracks and grease leaks on the ball joint dust cover.


