2014 Hilux · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built from Jun 2011

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. REMOVE FRONT WHEEL

2. REMOVE FRONT SPEED SENSOR LH

F042730E03
  1. Remove the bolt and speed sensor.

  1. Disconnect the 2 clamps.

  1. Remove the bolt and disconnect the speed sensor wire harness from the steering knuckle.


3. REMOVE FRONT DISC BRAKE CALIPER ASSEMBLY LH

F042731E01
  1. Remove the bolt and disconnect the brake tube bracket from the steering knuckle.

  1. F050777E01
    Using SST, disconnect the brake tube from the disc brake caliper.
    SST
    09023-00101  

  1. F050211E01
    Remove the 2 bolts and disc brake caliper.


4. REMOVE FRONT DISC

5. REMOVE FRONT AXLE HUB GREASE CAP (for 4WD)

F042729E01
  1. Using a screwdriver and hammer, remove the grease cap.

    NOTICE:
    Do not damage the axle hub.


6. REMOVE FRONT AXLE HUB NUT (for 4WD)

F042732E01
  1. Remove the cotter pin and lock cap.

  1. Remove the hub nut.


7. REMOVE FRONT AXLE HUB ASSEMBLY

F042759E01
  1. Remove the 4 bolts, dust cover and axle hub from the steering knuckle.

  1. Remove the O-ring from the axle hub.

  1. 4WD w/ ABS:
    Remove the spacer and ABS rotor from the axle hub.

  1. 4WD w/o ABS:
    Remove the 2 spacers from the axle hub.


8. REMOVE FRONT AXLE BEARING ASSEMBLY (for 4WD)

F042760E01
  1. Fix the front axle hub in a soft vise.

  1. Using SST, remove the bearing.

    SST
    09710-30021   (09710-03051)
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04061, 09957-04010, 09958-04011)


9. REMOVE FRONT AXLE BEARING ASSEMBLY (for Pre-Runner)

F042757E01
  1. Using SST and a hammer, unstake the adjusting nut.

    SST
    09930-00010  

  1. C119748E01
    Using SST, remove the adjusting nut.
    SST
    09318-12010  

  1. w/o ABS:
    Remove the spacer from the axle hub.

  1. w/ ABS:
    Remove the sensor rotor from the axle hub.

  1. F042760E01
    Fix the front axle hub in a soft vise.

  1. Using SST, remove the bearing.

    SST
    09710-30021   (09710-03051)
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04061, 09957-04010, 09958-04011)


10. REMOVE FRONT AXLE HUB OIL SEAL

F042761E01
  1. Using a screwdriver, pry out the oil seal.


11. REMOVE PLUG (for Pre-Runner)
← ON-VEHICLE INSPECTION (from Jun 2011)INSTALLATION (Jun 2011 – Jul 2013) →