Parking Brake Switch Circuit
Circuit diagnosis · Vehicles built Aug 2012 – Jul 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
DESCRIPTION
This circuit is from the parking brake switch assembly to the radio and display receiver assembly.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT PARKING BRAKE SWITCH ASSEMBLY |
 |
- Remove the parking brake switch assembly (Click here).
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
|
Switch Condition
|
Specified Condition
|
Switch connector - Switch body
|
On (Shaft is not pressed)
|
Below 1 Ω
|
Off (Shaft is pressed)
|
10 kΩ or higher
|
Text in Illustration
 
|
On
|
 
|
Off
|
|
NG |
 |
|
| REPLACE PARKING BRAKE SWITCH ASSEMBLY (Click here)
|
|
|
| OK |
|
 |
|
| 2. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER - PARKING BRAKE SWITCH) |
 |
Disconnect the R18 radio and display receiver assembly connector.
Disconnect the P2 parking brake switch assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
R18-6 (PKB) - P2-1
|
Always
|
Below 1 Ω
|
R18-6 (PKB) - Body ground
|
Always
|
10 kΩ or higher
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|