Parking Brake Switch Circuit
Circuit diagnosis · Vehicles built from Aug 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
DESCRIPTION
This circuit is from the parking brake switch assembly to the radio and display receiver assembly.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK PARKING BRAKE SWITCH ASSEMBLY |
 |
- Enter the "Vehicle Signal Check Mode" screen. [Refer to Check Touch Switch in Operation Check (Click here)]
Check that the display changes between ON and OFF according to the parking brake operation.
- OK:
Parking Brake Condition
|
Display
|
Applied
|
ON
|
Released
|
OFF
|
- HINT:
- This display is updated once per second. As a result, it is normal for the display to lag behind the actual parking brake operation.
|
NG |
 |
|
|
|
| OK |
|
 |
|
| PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|
| 2. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - PARKING BRAKE SWITCH ASSEMBLY) |
 |
Disconnect the R21 radio and display receiver assembly connector.
Disconnect the P2 parking brake switch assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
R21-15 (PKB) - P2-1
|
Always
|
Below 1 Ω
|
R21-15 (PKB) - Body ground
|
Always
|
10 kΩ or higher
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| 3. INSPECT PARKING BRAKE SWITCH ASSEMBLY |
 |
- Remove the parking brake switch assembly (Click here).
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
Switch connector - Switch body
|
On (Shaft is not pressed)
|
Below 1 Ω
|
Off (Shaft is pressed)
|
10 kΩ or higher
|
Text in Illustration
 
|
On
|
 
|
Off
|
|
NG |
 |
|
| REPLACE PARKING BRAKE SWITCH ASSEMBLY (Click here)
|
|
|
| OK |
|
 |
|
| PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|