2014 Hilux · Service Manual BODY ELECTRICAL

Parking Brake Switch Circuit

Circuit diagnosis · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

DESCRIPTION

This circuit is from the parking brake switch assembly to the radio and display receiver assembly.

WIRING DIAGRAM

C240177E05

INSPECTION PROCEDURE


1. INSPECT PARKING BRAKE SWITCH ASSEMBLY

  1. C217121
    Remove the parking brake switch assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    Switch connector - Switch body
    On (Shaft is not pressed)
    Below 1 Ω
    Off (Shaft is pressed)
    10 kΩ or higher
    Text in Illustration 
    V100135
    On
    V100136
    Off



NG
REPLACE PARKING BRAKE SWITCH ASSEMBLY (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER - PARKING BRAKE SWITCH)
  1. Disconnect the R18 radio and display receiver assembly connector.

  1. Disconnect the P2 parking brake switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R18-6 (PKB) - P2-1
    Always
    Below 1 Ω
    R18-6 (PKB) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Illumination Circuit (from Aug 2013)Parking Brake Switch Circuit (Aug 2012 – Jul 2013) →