2014 Hilux · Service Manual BODY ELECTRICAL

Entire Combination Meter does not Operate

Circuit diagnosis · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

DESCRIPTION

This circuit is the power source circuit for the meter.

WIRING DIAGRAM

E224860E03

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - BATTERY AND BODY GROUND)

  1. E224604E03
    Disconnect the C25 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    C25-22 (EP) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    C25-1 (B) - Body ground
    Always
    11 to 14 V
    C25-21 (IG+) - Body ground
    Ignition switch ON
    11 to 14 V
    C25-21 (IG+) - Body ground
    Ignition switch off
    Below 1 V

Text in Illustration 
*a
Front view of wire harness connector
(to Combination Meter Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)


← Entire Combination Meter does not Operate (Aug 2012 – Jul 2013)Speedometer Malfunction (Jun 2011 – Jul 2012) →