REMOVAL
Removal / installation · Vehicles built Jun 2011 – Jul 2012
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
- HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
- A bolt without a torque specification is shown in the standard bolt chart (Click here).
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2.
REMOVE FRONT SEAT ASSEMBLY LH |
 |
Remove the front seat assembly LH (Click here)
| 3.
REMOVE FRONT SEAT ASSEMBLY RH |
 |
Remove the front seat assembly RH (Click here).
| 4.
REMOVE FRONT DOOR SCUFF PLATE LH
|
 |
Put protective tape around the front door scuff plate.
Text in Illustration
*1
|
Protective Tape
|
Using a moulding remover, detach the 7 claws and 3 clips, and remove the front door scuff plate.
| 5.
REMOVE FRONT DOOR OPENING TRIM LH |
|
| 6.
REMOVE REAR DOOR SCUFF PLATE LH
|
 |
Put protective tape around the rear door scuff plate.
Text in Illustration
*1
|
Protective Tape
|
Using a moulding remover, detach the 7 claws and 2 clips, and remove the rear door scuff plate.
| 7.
REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH |
|
| 8.
REMOVE CENTER PILLAR GARNISH LOWER LH
|
 |
Remove the bolt and disconnect the front seat outer belt floor anchor.
- Detach the 2 claws, 2 guides and 2 clips and remove the lower center pillar garnish.
| 9.
REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH |
 |
- Remove the outer belt shoulder anchor.
Using a screwdriver, detach the 4 claws and remove the seat belt anchor cover cap.
- HINT:
- Tape the screwdriver tip before use.
Remove the bolt and shoulder anchor.
- Remove the bolt and seat belt.
- w/ Pretensioner:
Disconnect the pretensioner connector as shown in the illustration.
- Remove the bolt and seat belt.
| 10.
REMOVE CENTER PILLAR GARNISH LH
|
 |
Using a screwdriver, detach the 4 claws and remove the front seat belt shoulder anchor cover.
- HINT:
- Tape the screwdriver tip before use.
Text in Illustration
*1
|
Protective Tape
|
Remove the bolt and disconnect the front seat belt shoulder anchor.
- Detach the clip.
Pull the center pillar garnish in the direction indicated by the arrow in the illustration to detach the guide and remove the center pillar garnish.
| 11.
REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY |
 |
Remove the bolt.
Rotate the adjuster approximately 90° , and then pull and remove it.
| 12.
REMOVE SHOULDER BELT ANCHORAGE PLATE COVER |
 |
Remove the plate cover.