Illumination Circuit
Circuit diagnosis · Vehicles built from Aug 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
DESCRIPTION
Power is supplied to the radio and display receiver assembly and steering pad switch assembly illumination when the headlight dimmer switch assembly is in the tail or head position.WIRING DIAGRAM


INSPECTION PROCEDURE
- CAUTION:
- The vehicle is equipped with an SRS (Supplemental Restraint System) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precautionary notice for the SRS (Click here).
| 1. CHECK ILLUMINATION |
Check if the illumination for the radio and display receiver assembly, steering pad switch assembly, glove box or other parts (hazard switch, transmission control switch, etc.) comes on when the headlight dimmer switch is turned to the head or tail position.
Result Result
Proceed to
Illumination comes on for all components except steering pad switch assembly.
A
Illumination comes on for all components except radio and display receiver assembly.
B
No illumination comes on (radio and display receiver assembly, hazard switch, glove box, etc.).
C
|
|
||||
|
|
||||
| A | |
| 2. CHECK HARNESS AND CONNECTOR (SPIRAL CABLE SUB-ASSEMBLY - BATTERY) |
Disconnect the spiral cable sub-assembly connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
S42-12 (IL+2) - Body ground
Headlight dimmer switch assembly tail or head position
11 to 14 V
Text in Illustration *a
Front view of wire harness connector
(to Spiral Cable Sub-assembly)
|
|
||||
| OK | |
| 3. INSPECT STEERING PAD SWITCH |
- *1: w/ Accessory Meter
- *2: wo/ Accessory Meter
Remove the steering pad switch assembly*1 or steering pad switch LH*2 (Click here).
Inspect the steering pad switch assembly*1 or steering pad switch LH*2 (Click here).
|
|
||||
| OK | |
| 4. INSPECT SPIRAL CABLE SUB-ASSEMBLY |
Remove the spiral cable sub-assembly (Click here).
Inspect the spiral cable sub-assembly (Click here).
|
|
||||
| OK | |
| 5. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - SPIRAL CABLE SUB-ASSEMBLY) |
Disconnect the R21 radio and display receiver assembly connector.
Disconnect the S42 spiral cable sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
R21-23 (SWG) - S42-4 (EAU)
Always
Below 1 Ω
R21-23 (SWG) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
| 6. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - BATTERY AND BODY GROUND) |
Disconnect the radio and display receiver assembly connector.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
R23-7 (GND) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
R23-10 (ILL+) - Body ground
Headlight dimmer switch assembly tail or head position
11 to 14 V
Text in Illustration *a
Front view of wire harness connector
(to Radio and Display Receiver Assembly)
|
|
||||
| OK | ||
| ||
