Entire Combination Meter does not Operate
Circuit diagnosis · Vehicles built Jun 2011 – Jul 2012
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
DESCRIPTION
This circuit is the power source circuit for the meter.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - BATTERY AND BODY GROUND) |
Disconnect the C25 combination meter assembly connector.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
C25-22 (EP) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
C25-1 (B) - Body ground
Always
11 to 14 V
C25-21 (IG+) - Body ground
Ignition switch ON
11 to 14 V
C25-21 (IG+) - Body ground
Ignition switch off
Below 1 V
| *a |
Front view of wire harness connector (to Combination Meter Assembly) |
|
|
||||
| OK | ||
| ||
