2014 Hilux · Service Manual HEATER & AIR CONDITIONING SYSTEM

REMOVAL

Removal / installation · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013


1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. A/C switch is ON.

  1. Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Using SST, Recover the refrigerant from the A/C system using a refrigerant recovery unit.

    SST
    09985-20010   (09985-02130, 09985-02150, 09985-02090, 09985-02110, 09985-02010, 09985-02050, 09985-02060, 09985-02070)


2. REMOVE AIR CLEANER ASSEMBLY
  1. w/ EGR Cooler:
    (Click here)

  1. w/o EGR Cooler:
    (Click here)


3. REMOVE FAN AND GENERATOR V BELT

  1. G035153E01
    Using the pulley set bolt of the tensioner, rotate the tensioner pulley clockwise to loosen the belt's tension. Then remove the V belt.


4. DISCONNECT SUCTION HOSE SUB-ASSEMBLY

E225064
  1. Remove the bolt and disconnect the suction hose sub-assembly from the compressor.

  1. Remove the O-ring from the suction hose sub-assembly.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.


5. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

E225065
  1. Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the compressor.

  1. Remove the O-ring from the No. 1 cooler refrigerant discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.


6. REMOVE COOLER COMPRESSOR ASSEMBLY

  1. E225066
    Disconnect the connector.

  1. E225067
    Remove the 4 bolts and cooler compressor assembly.

← REMOVAL (Aug 2012 – Jul 2013)DISASSEMBLY (from Jun 2011) →