REMOVAL
Removal / installation · Vehicles built Aug 2012 – Jul 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
| 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM |
Start up the engine.
A/C switch is ON.
Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.
Stop the engine.
Using SST, Recover the refrigerant from the A/C system using a refrigerant recovery unit.
- SST
- 09985-20010
(09985-02130, 09985-02150, 09985-02090, 09985-02110, 09985-02010, 09985-02050, 09985-02060, 09985-02070)
| 2. REMOVE AIR CLEANER ASSEMBLY |
w/ EGR Cooler:
(Click here)
w/o EGR Cooler:
(Click here)
| 3. REMOVE FAN AND GENERATOR V BELT |
Using the pulley set bolt of the tensioner, rotate the tensioner pulley clockwise to loosen the belt's tension. Then remove the V belt.

| 4. DISCONNECT SUCTION HOSE SUB-ASSEMBLY |
![]() ![]() |
Remove the bolt and disconnect the suction hose sub-assembly from the compressor.
Remove the O-ring from the suction hose sub-assembly.
- NOTICE:
- Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.
| 5. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE |
![]() ![]() |
Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the compressor.
Remove the O-ring from the No. 1 cooler refrigerant discharge hose.
- NOTICE:
- Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.
| 6. REMOVE COOLER COMPRESSOR ASSEMBLY |
Disconnect the connector.

Remove the 4 bolts and cooler compressor assembly.



