REMOVAL
Removal / installation · Vehicles built from Jun 2011
| 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM |
Start up the engine.
A/C switch is ON.
Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.
Stop the engine.
Using SST, Recover the refrigerant from the A/C system using a refrigerant recovery unit.
- SST
- 09985-20010
(09985-02130, 09985-02150, 09985-02090, 09985-02110, 09985-02010, 09985-02050, 09985-02060, 09985-02070)
| 2. REMOVE FRONT BUMPER COVER |
| 3. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE |
![]() ![]() |
Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the cooler condenser.
Remove the O-ring from the No. 1 cooler refrigerant discharge hose.
- NOTICE:
- Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.
| 4. DISCONNECT AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY |
![]() ![]() |
Remove the bolt and disconnect the air conditioning tube and accessory assembly from the cooler condenser.
Remove the O-ring from the air conditioning tube and accessory assembly.
- NOTICE:
- Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.
| 5. REMOVE HOOD LOCK ASSEMBLY |
for LHD:
(Click here)
for RHD:
(Click here)
| 6. REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY |
![]() ![]() |
Remove the 7 bolts and upper radiator support sub-assembly.
| 7. REMOVE COOLER CONDENSER ASSEMBLY |
![]() ![]() |
Remove the cooler condenser assembly.





