2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jun 2011

CAUTION:
  1. Wear protective gloves when removing the exhaust pipe assembly.
  2. The exhaust pipe assembly is extremely hot immediately after the engine has stopped.
  3. Confirm that the exhaust pipe assembly has cooled down before removing it.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE TAILPIPE ASSEMBLY
  1. Remove the 2 bolts and 2 nuts.

  1. Disconnect the tailpipe from the center pipe and remove the gasket.

  1. Remove the tailpipe from the pipe support.


3. REMOVE CENTER EXHAUST PIPE ASSEMBLY
  1. Remove the 2 bolts and 2 nuts.

  1. Disconnect the center pipe from the front pipe and remove the gasket.

  1. Remove the center pipe from the 3 pipe supports.


4. REMOVE AIR FUEL RATIO SENSOR (w/ Secondary Air Injection System)

  1. A112091
    Disconnect the sensor connector.

  1. Detach the 3 wire clamps.

  1. A112092
    Using SST, remove the sensor.
    SST
    09224-00010  


5. REMOVE HEATED OXYGEN SENSOR (w/o Secondary Air Injection System)

  1. A112091
    Disconnect the sensor connector.

  1. Detach the 3 wire clamps.

  1. A112092
    Using SST, remove the sensor.
    SST
    09224-00010  


6. REMOVE HEATED OXYGEN SENSOR (w/ Secondary Air Injection System)
  1. for 2WD: (Click here)
  2. for 4WD: (Click here)

7. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Remove the 2 bolts and 2 compression springs.

  1. Disconnect the front pipe from the exhaust manifold and remove the gasket.

  1. Remove the front pipe from the pipe support.

← COMPONENTS (from Jun 2011)INSTALLATION (Jun 2011 – Jul 2012) →