REMOVAL
Removal / installation · Vehicles built from Jun 2011
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY (4WD) |
| 3. REMOVE NO. 2 ENGINE COVER SUB-ASSEMBLY (4WD) |
| 4. REMOVE FRONT PROPELLER SHAFT ASSEMBLY (4WD) |
Remove the front propeller shaft (Click here).
| 5. REMOVE REAR PROPELLER SHAFT ASSEMBLY |
Remove the rear propeller shaft (Click here).
| 6. REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY |
Remove the manual transmission unit.
G58 manual transmission (Click here).
G58F manual transmission (Click here).
| 7. REMOVE CLUTCH RELEASE BEARING ASSEMBLY |
| 8. REMOVE CLUTCH RELEASE FORK BOOT |
| 9. REMOVE CLUTCH RELEASE FORK SUB-ASSEMBLY |
| 10. REMOVE RELEASE BEARING HUB CLIP |
| 11. REMOVE RELEASE FORK SUPPORT |
Remove the release fork support from the manual transmission unit.
| 12. REMOVE CLUTCH COVER ASSEMBLY |
Place matchmarks on the clutch cover and flywheel.

Loosen each set bolt 1 turn at a time until spring tension is released.
Remove the 6 set bolts and pull off the clutch cover.
- NOTICE:
- Do not drop the clutch disc.
| 13. REMOVE CLUTCH DISC ASSEMBLY |
- NOTICE:
- Keep the lining part of the clutch disc, pressure plate and surface of the flywheel away from oil and foreign matter.
| 14. INSPECT INPUT SHAFT FRONT BEARING |
Turn the bearing by hand by applying rotational force.

If the bearing sticks or has much resistance, replace the input shaft bearing.- HINT:
- The bearing is permanently lubricated and requires no cleaning or lubrication.
| 15. REMOVE INPUT SHAFT FRONT BEARING |
Remove any 2 diametrically opposite bolts.

Using SST, remove the input shaft bearing.
- SST
- 09303-35011
| 16. INSPECT CLUTCH DISC ASSEMBLY |
Using a vernier caliper, measure the rivet head depth.

- Minimum rivet depth:
- 0.3 mm (0.012 in)
Install the clutch disc to the transmission unit.

- NOTICE:
- Be careful not to insert the clutch disc facing the wrong direction.
Using a dial indicator, check the disc runout.
- Maximum runout:
- 0.8 mm (0.031 in.)
| 17. INSPECT CLUTCH COVER ASSEMBLY |
Using a vernier caliper, measure the depth and width of the worn areas of the diaphragm spring.

- Maximum depth and width:
Measurement
Specified Condition
A (Depth)
0.5 mm (0.020 in.)
B (Width)
6.0 mm (0.236 in.)
| 18. INSPECT FLYWHEEL SUB-ASSEMBLY |
Using a dial indicator, measure the flywheel runout.

- Maximum runout:
- 0.1 mm (0.004 in.)
| 19. INSPECT CLUTCH RELEASE BEARING ASSEMBLY |
Turn the bearing by hand while applying force in the axial direction.

If the bearing sticks or has much resistance, replace the release bearing.- HINT:
- The bearing is permanently lubricated and requires no cleaning or lubrication.
