2014 Hilux · Service Manual STEERING

INSTALLATION

Removal / installation · Vehicles built Aug 2012 – Jul 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013


1. INSTALL VANE PUMP ASSEMBLY

  1. F051260E01
    Install the vane pump with the 2 bolts.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }

  1. F051259E02
    Install the wire harness clamp bracket with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the oil pressure switch connector.

    NOTICE:
    Make sure that no oil adheres to the connector.


2. CONNECT PRESSURE FEED TUBE ASSEMBLY

C112619
  1. Install a new gasket onto the pressure feed tube.

  1. Install the pressure feed tube with the union bolt.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }


3. CONNECT OIL RESERVOIR TO PUMP HOSE

F051257E01
  1. Connect the hose with the clip.


4. INSTALL FAN AND GENERATOR V BELT

A076442E01
  1. While turning the belt tensioner counterclockwise, align its holes, and then insert a bar of 6 mm (0.24 in.) into the holes to fix the belt tensioner.

  1. Install the V-ribbed belt.

  1. While turning the belt tensioner counterclockwise, remove the bar.

  1. A113028E02
    If it is hard to install the V-ribbed belt, perform the following procedure.

    1. Put the V-ribbed belt on everything except the P/S pump as shown in the illustration.

    2. While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the P/S pump.


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

6. PERFORM INITIALIZATION
  1. Perform initialization (Click here ).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.


7. ADD POWER STEERING FLUID
(Click here)

8. BLEED POWER STEERING FLUID

9. CHECK FOR POWER STEERING FLUID LEAKAGE
← INSTALLATION (Jun 2011 – Jul 2012)INSTALLATION (from Aug 2013) →