2014 Hilux · Service Manual BODY ELECTRICAL

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

HINT:
Use these procedures to troubleshoot the rear view monitor system.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
      NEXT

      3.CHECK DTC OF AUDIO AND VISUAL SYSTEM (for Radio and Display Type)
      1. Refer to DTC Check/Clear procedures of the audio and visual system (for Radio and Display Type) (Click here).

        Result 
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B


      B.
      A

      4.PROBLEM SYMPTOM CONFIRMATION
        Result 
        Result
        Proceed to
        Symptom does not occur
        A
        Symptom occurs
        B

      B.
      A

      5.SYMPTOM SIMULATION
        NEXT

        6.CHECK IF SAME SYMPTOM APPEARS IN AUDIO AND VISUAL SYSTEM (for Radio and Display Type)
        1. Refer to the audio and visual system (for Radio and Display Type) (Click here).

          Result 
          Result
          Proceed to
          Symptom does not appear
          A
          Symptom appears
          B


        B.
        A

        7.PROBLEM SYMPTOMS TABLE
        1. Refer to the problem symptoms table (Click here).

          Result 
          Result
          Proceed to
          Fault is not listed in problem symptoms table
          A
          Fault is listed in problem symptoms table
          B


        B.
        A

        8.BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW
        1. Terminals of ECU (Click here).

        NEXT

        9.ADJUST, REPAIR OR REPLACE
          NEXT

          10.CONFIRMATION TEST
            NEXT

            ← HOW TO PROCEED WITH TROUBLESHOOTING (Aug 2012 – Jul 2013)PROBLEM SYMPTOMS TABLE (Jun 2011 – Jul 2012) →