2014 Hilux · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 from Aug 2012


INSPECT EGR VALVE

  1. Inspect the EGR valve.

    1. A099571E01
      When a vacuum of 26.7 kPa (200 mmHg, 7.87 in.Hg) is applied to the diaphragm chamber, check that the shaft rises and that air flows out.

    2. Maintaining the above conditions, check that there are no leaks and that the shaft does not lower.

    3. Check that the valve does not have heavy carbon deposits and is not stuck.
      If the result is not as specified, replace the EGR valve.

  1. A085764E03
    Inspect the EGR valve position sensor.

    1. Measure the resistance between terminals 1 (VC) and 2 (E2) of the EGR valve position sensor.

      Standard resistance:
      2.8 to 7.8 kΩ at 20°C (68°F)

      If the result is not as specified, replace the EGR valve.

  1. A099572E03
    Create a vacuum in the diaphragm chamber. Check the resistance between terminals 3 (EGLS) and 2 (E2) of the lift sensor when the valve is fully opened and fully closed.

    Standard resistance:
    EGR Valve Condition
    Specified Condition
    Fully opened
    2.0 to 7.0 kΩ at 20°C (68°F)
    Fully closed
    0.1 to 2.5 kΩ at 20°C (68°F)

    HINT:
    The resistance increases in proportion to the opening angle of the EGR valve.
    If the result is not as specified, replace the EGR valve.

← REMOVAL (from Aug 2013)INSPECTION (from Aug 2012) →