After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
2.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
3.
REMOVE NO. 1 ENGINE UNDER COVER (for 4WD)
4.
REMOVE NO. 2 ENGINE UNDER COVER (for 4WD)
5.
DRAIN ENGINE COOLANT
NOTICE:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.
Loosen the cylinder block drain cock plug and the radiator drain cock plug.
HINT:
Collect the coolant in a container and dispose of it according to the regulations in your area.
6.
REMOVE FRONT FENDER APRON SEAL UPPER
for 4WD: Remove the 5 clips and front fender apron seal upper.
for 2WD: Remove the 6 clips and front fender apron seal upper.
7.
REMOVE FRONT FENDER SEAL
Remove the 5 clips and front fender seal.
8.
REMOVE FRONT EXHAUST PIPE ASSEMBLY
Remove the 2 bolts and 2 compression springs.
Disconnect the front pipe from the outlet pipe and remove the gasket.
Remove the front pipe from the pipe support.
9.
REMOVE AIR CLEANER ASSEMBLY
Disconnect the mass air flow meter connector and remove the clamp.
Loosen the hose clamp of the compressor inlet elbow.