2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Aug 2012 – Jul 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013


1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE NO. 1 ENGINE UNDER COVER (for 4WD)

4. REMOVE NO. 2 ENGINE UNDER COVER (for 4WD)

5. DRAIN ENGINE COOLANT

NOTICE:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. A099591E01
    Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.

  1. Loosen the cylinder block drain cock plug and the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.


    A112147E01


6. REMOVE FRONT FENDER APRON SEAL UPPER
  1. for 4WD:
    Remove the 5 clips and front fender apron seal upper.

  1. for 2WD:
    Remove the 6 clips and front fender apron seal upper.


7. REMOVE FRONT FENDER SEAL
  1. Remove the 5 clips and front fender seal.


8. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Remove the 2 bolts and 2 compression springs.

  1. Disconnect the front pipe from the outlet pipe and remove the gasket.

  1. Remove the front pipe from the pipe support.


9. REMOVE AIR CLEANER ASSEMBLY

A099628E02
  1. Disconnect the mass air flow meter connector and remove the clamp.

  1. Loosen the hose clamp of the compressor inlet elbow.

  1. Remove the 2 bolts and air cleaner assembly.


10. REMOVE INTERCOOLER ASSEMBLY
(Click here)

11. REMOVE VENTILATION PIPE

  1. A288742
    for LHD:
    Disconnect the No. 12 water by-pass hose and No. 13 water by-pass hose.

  1. A288747E01
    Remove the bolt and ventilation pipe.
    Text in Illustration 
    *A
    for RHD
    *B
    for LHD


12. REMOVE COMPRESSOR INLET ELBOW (for LHD)

  1. A288737
    Disconnect the 2 connectors and detach the wire harness clamp.

  1. A291249
    Disconnect the No. 1 turbo water hose.

  1. A288735E01
    Disconnect the No. 2 water by-pass hose and No. 13 water by-pass hose.
    Text in Illustration 
    *1
    No. 2 Water By-pass Hose
    *2
    No. 13 Water By-pass Hose

  1. Remove the 2 nuts, compressor inlet elbow and gasket.

  1. A288733E01
    Remove the No. 7 water by-pass hose and No. 12 water by-pass hose.
    Text in Illustration 
    *1
    No. 7 Water By-pass Hose
    *2
    No. 12 Water By-pass Hose


13. REMOVE COMPRESSOR INLET ELBOW (for RHD)

  1. A288737
    Disconnect the 2 connectors and detach the wire harness clamp.

  1. Remove the 2 nuts, compressor inlet elbow and gasket.

  1. A211835
    Disconnect the 2 No. 1 turbo water hoses.


14. REMOVE NO. 1 TURBO INSULATOR

  1. A255740
    Remove the 2 bolts and No. 1 turbo insulator.


15. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

A255741
  1. Remove the bolt and No. 1 exhaust manifold heat insulator.


16. REMOVE TURBINE OUTLET ELBOW

A098816E01
  1. Remove the 3 nuts, outlet elbow and gasket.


17. REMOVE TURBOCHARGER STAY

A099944E02
  1. Remove the 2 bolts, nut and stay.


18. REMOVE TURBO OIL INLET PIPE SUB-ASSEMBLY

A098817E02
  1. Remove the 2 bolts, 2 nuts, union bolt, inlet pipe sub-assembly and 3 gaskets.

    NOTICE:
    Do not loosen the nut labeled A.


19. REMOVE TURBOCHARGER SUB-ASSEMBLY

A098818E01
  1. Remove the 3 nuts, turbocharger sub-assembly and gasket.


20. REMOVE NO. 1 TURBO WATER PIPE SUB-ASSEMBLY

  1. A288732
    Remove the 2 nuts, bolt, No. 1 turbo water pipe sub-assembly and gasket.

  1. Disconnect the No. 1 turbo water hose from the No. 1 turbo water pipe sub-assembly.

← REMOVAL (Jun 2011 – Jul 2012)REMOVAL (from Aug 2013) →