2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DRAIN ENGINE COOLANT

NOTICE:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. A099591E01
    Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.

  1. Loosen the cylinder block drain cock plug and the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.


    A112147E01


3. REMOVE FRONT WHEEL RH

4. REMOVE FRONT FENDER APRON SEAL UPPER
  1. Remove the 5 clips and apron seal.


5. REMOVE FRONT FENDER SEAL
  1. Remove the 5 clips and fender seal.


6. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Remove the 2 bolts and 2 compression springs.

  1. Disconnect the front pipe from the outlet pipe and remove the gasket.

  1. Remove the front pipe from the pipe support.


7. REMOVE AIR CLEANER ASSEMBLY

A099628E02
  1. Disconnect the MAF meter connector and remove the clamp.

  1. Loosen the hose clamp of the compressor inlet elbow.

  1. for Ventilation Hose Type:
    Disconnect the ventilation hose.

  1. Remove the 2 bolts and air cleaner.


8. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

  1. A110362
    Remove the 3 bolts, 2 nuts and cover.


9. REMOVE INTERCOOLER ASSEMBLY WITH INTAKE AIR CONNECTOR
  1. Remove the intercooler assembly with intake air connector (Click here).


10. REMOVE COMPRESSOR INLET ELBOW

  1. A110341
    for Ventilation Pipe Type:
    Remove the ventilation pipe.

    1. Move the clamp so that the hose can be disconnected.

    2. Remove the ventilation pipe.

  1. Disconnect the 2 connectors from the turbocharger.

  1. Remove the wire clamp's clip from the inlet elbow.

  1. Remove the 2 nuts, inlet elbow and gasket.


11. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

A110342
  1. Remove the 2 bolts and heat insulator.


12. REMOVE NO. 1 TURBO INSULATOR
  1. Remove the bolt and insulator.


13. REMOVE NO. 1 TURBO WATER HOSE

A098815E01
  1. Move the 2 clamps and disconnect the 2 hoses.


14. REMOVE TURBINE OUTLET ELBOW

A098816E01
  1. Remove the 3 nuts, outlet elbow and gasket.


15. REMOVE TURBOCHARGER STAY

A099944E02
  1. Remove the 2 bolts, nut and stay.


16. REMOVE TURBO OIL INLET PIPE SUB-ASSEMBLY

A098817E02
  1. Remove the 2 bolts, 2 nuts, union bolt, inlet pipe and 3 gaskets.

    NOTICE:
    Do not loosen the nut labeled A.


17. REMOVE TURBOCHARGER SUB-ASSEMBLY

A098818E01
  1. Remove the 3 nuts, turbocharger and gasket.

← SYSTEM DESCRIPTION (from Aug 2013)REMOVAL (Aug 2012 – Jul 2013) →