2014 Hilux · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Aug 2012

Versions by build date: Jun 2011 – Jul 2012 from Aug 2012


VISUALLY CHECK TURBOCHARGER SUB-ASSEMBLY

  1. Check for deformation and cracks in the turbine wheel on the exhaust side.

    A287047E01

    Text in Illustration 
    *A
    w/o Intercooler
    *B
    w/ Intercooler
    *1
    Turbine Wheel
    -
    -
    If the turbine wheel is cracked or deformed, replace the turbocharger sub-assembly.


INSPECT AXIAL PLAY OF TURBINE SHAFT

  1. A287048E01
    Using a dial indicator, insert the needle of the dial indicator into the exhaust side of the turbine shaft.
    Text in Illustration 
    *A
    w/o Intercooler
    *B
    w/ Intercooler

    NOTICE:
    Turbocharger sub-assembly and dial indicators are surely fixed when performing measurement.

  1. Move the turbine shaft in an axial direction and measure the axial play of the turbine shaft.

    Maximum Axial Play:
    Item
    Specified Condition
    w/o Intercooler
    0.08 mm (0.0031 in.)
    w/ Intercooler
    0.11 mm (0.00433 in.)

    If the axial play is more than the maximum, replace the turbocharger sub-assembly.


INSPECT RADIAL PLAY OF TURBINE SHAFT (w/o Intercooler)

  1. A254008
    Using a dial indicator, insert the needle of the dial indicator into the oil outlet hole, and set it in the center of the turbine shaft.

  1. Move the turbine shaft in a radial direction and measure the radial play of the turbine shaft.

    Maximum Radial Play:
    0.110 mm (0.0043 in.)

    If the radial play is more than the maximum, replace the turbocharger sub-assembly.


CHECK TURBINE SHAFT ROTATION

  1. A287050E01
    Rotate the turbine wheel on the exhaust side with your finger and check that it rotates smoothly.
    Text in Illustration 
    *A
    w/o Intercooler
    *B
    w/ Intercooler

    HINT:
    Even if it takes a little effort to rotate the turbine wheel, this is not a problem.

    If the turbine wheel does not rotate smoothly, replace the turbocharger sub-assembly.


INSPECT ACTUATOR AND WASTE GATE VALVE OPERATION (w/o Intercooler)
  1. Disconnect the actuator hose from the compressor housing.

  1. A099568E02
    Using SST, apply pressure to the actuator.
    SST
    09992-00242  

    Valve opening pressure:
    Specified pressure* (See attached table below)

    NOTICE:
    Never apply more than predetermined maximum pressure* to the actuator.

    HINT:
    *: For the specifications, refer to the table below.

  1. Check that the actuator push rod moves and that the waste gate valve opens.

    Specifications:
    Valve Opening Pressure
    (Gauge Pressure)
    Maximum Pressure
    (Gauge Pressure)
    Rod Stroke
    (Reference)
    108 kPa (1.10 kgf/cm2, 15 psi)
    136 kPa (1.40 kgf/cm2, 20 psi)
    2.0 to 4.50 mm (0.0787 to 0.177 in.)

    If the rod does not move, replace the turbocharger sub-assembly.

  1. Reconnect the actuator hose to the compressor housing.

← INSPECTION (Jun 2011 – Jul 2012)INSTALLATION (Jun 2011 – Jul 2012) →