2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 4 bolts and cover.


3. REMOVE FRONT WHEEL RH

4. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Remove the 2 bolts and 2 compression springs.

  1. Disconnect the front pipe from the outlet pipe and remove the gasket.

  1. Remove the front pipe from the pipe support.


5. REMOVE FRONT FENDER APRON SEAL UPPER
  1. Remove the 5 clips and apron seal.


6. REMOVE FRONT FENDER SEAL
  1. Remove the 5 clips and fender seal.


7. REMOVE VENTILATION HOSE HEAT INSULATOR
  1. Remove the 2 bolts and insulator.


8. REMOVE AIR CLEANER ASSEMBLY

  1. w/ Mass Air Flow Meter:

    1. A252009
      Disconnect the mass air flow meter connector and detach the wire harness clamp.

    2. Loosen the hose clamp, and then remove the air cleaner hose from the turbocharger.

    3. Disconnect the ventilation hose and remove the 2 bolts and air cleaner.

  1. w/o Mass Air Flow Meter:

    1. A110353
      Remove the clamp and disconnect the intake air temperature sensor connector.

    2. Loosen the clamp of the turbocharger.

    3. Slide the clamp and disconnect the ventilation hose.

    4. Remove the 2 bolts and air cleaner.


9. REMOVE NO. 2 AIR CLEANER PIPE SUB-ASSEMBLY

A098889E06
  1. Disconnect the manifold absolute pressure sensor connector.

  1. Disconnect the vacuum hose from the gas filter.

  1. Loosen the 2 clamps of the No. 1 and No. 2 air hoses.

  1. Remove the bolt and cleaner pipe together with the 2 air hoses.


10. REMOVE TURBINE OUTLET ELBOW

A099515E02
  1. Remove the 2 bolts, 4 nuts, outlet elbow (with turbocharger stay) and gasket from the turbocharger.


11. REMOVE TURBOCHARGER SUB-ASSEMBLY

A098783E02
  1. Remove the 2 bolts and manifold stay.

  1. Remove the 2 bolts, union and 2 gaskets.

  1. A098784E02
    Remove the 3 nuts, turbocharger (with turbo oil pipe) and gasket.

  1. A110356
    Remove the 2 nuts, turbo oil pipe and gasket from the turbocharger.

← SYSTEM DESCRIPTION (from Aug 2013)REMOVAL (Aug 2012 – Jul 2013) →