2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Aug 2012 – Jul 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013


1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE NO. 1 ENGINE UNDER COVER (for 4WD and Pre-Runner)

4. REMOVE NO. 2 ENGINE UNDER COVER (for 4WD and Pre-Runner)

5. DRAIN ENGINE COOLANT (w/ Intercooler)

NOTICE:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. A099591E01
    Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.

  1. Loosen the cylinder block drain cock plug and the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.


    A112147E01


6. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Remove the 2 bolts and 2 compression springs.

  1. Disconnect the front pipe from the outlet pipe and remove the gasket.

  1. Remove the front pipe from the pipe support.


7. REMOVE FRONT FENDER APRON SEAL UPPER
  1. Remove the 5 clips and apron seal.


8. REMOVE FRONT FENDER SEAL
  1. Remove the 5 clips and fender seal.


9. REMOVE VENTILATION HOSE HEAT INSULATOR (w/o Intercooler)
  1. Remove the 2 bolts and insulator.


10. REMOVE INTERCOOLER ASSEMBLY
(Click here)

11. REMOVE AIR CLEANER ASSEMBLY

  1. w/ Mass Air Flow Meter:

    1. Disconnect the mass air flow meter connector and detach the wire harness clamp.

      A291271E01

      Text in Illustration 
      *A
      w/ Intercooler
      *B
      w/o Intercooler

    2. Loosen the hose clamp, and then remove the air cleaner hose from the turbocharger.

    3. w/o Intercooler:
      Disconnect the ventilation hose and remove the 2 bolts and air cleaner.

  1. w/o Mass Air Flow Meter:

    1. A110353
      Remove the clamp and disconnect the intake air temperature sensor connector.

    2. Loosen the clamp of the turbocharger.

    3. Slide the clamp and disconnect the ventilation hose.

    4. Remove the 2 bolts and air cleaner.


12. REMOVE VENTILATION PIPE (w/ Intercooler)

  1. A288744
    Remove the bolt and ventilation pipe.


13. REMOVE NO. 2 AIR CLEANER PIPE SUB-ASSEMBLY (w/o Intercooler)

A111789
  1. Disconnect the manifold absolute pressure sensor connector.

  1. Disconnect the vacuum hose from the gas filter.

  1. Loosen the 2 clamps.

  1. Remove the bolt and disconnect the pipe together with the 2 air hoses.


14. REMOVE COMPRESSOR INLET ELBOW (w/ Intercooler)

  1. A288737
    Disconnect the 2 connectors and detach the wire harness clamp.

  1. A288743
    Remove the 2 nuts, compressor inlet elbow and gasket.


15. REMOVE NO. 1 TURBO INSULATOR (w/ Intercooler)

  1. A255740
    Remove the 2 bolts and No. 1 turbo insulator.


16. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR (w/ Intercooler)

  1. A255741
    Remove the bolt and No. 1 exhaust manifold heat insulator.


17. REMOVE NO. 1 TURBO WATER HOSE (w/ Intercooler)

  1. A211835
    Disconnect the 2 No. 1 turbo water hoses.


18. REMOVE TURBINE OUTLET ELBOW

  1. A099515E02
    w/o Intercooler:
    Remove the 2 bolts, 4 nuts, outlet elbow (with turbocharger stay) and gasket from the turbocharger.

  1. A211836
    w/ Intercooler:
    Remove the 3 nuts, turbine outlet elbow and gasket.


19. REMOVE TURBOCHARGER STAY (w/ Intercooler)

  1. A211837
    Remove the 2 bolts, nut and turbocharger stay.


20. REMOVE TURBO OIL INLET PIPE SUB-ASSEMBLY (w/ Intercooler)

  1. A098817E02
    Remove the 2 bolts, 2 nuts, union bolt, turbo oil inlet pipe and 3 gaskets.

    NOTICE:
    Do not loosen the nut labeled A.


21. REMOVE TURBOCHARGER SUB-ASSEMBLY

  1. A098783E02
    w/o Intercooler:
    Remove the 2 bolts and manifold stay.

  1. Remove the 2 bolts, union and 2 gaskets.

  1. A098784E02
    Remove the 3 nuts, turbocharger (with turbo oil pipe) and gasket.

  1. A110356
    Remove the 2 nuts, turbo oil pipe and gasket from the turbocharger.

  1. A098818E01
    w/ Intercooler:
    Remove the 3 nuts, turbocharger and gasket.


22. REMOVE NO. 1 TURBO WATER PIPE SUB-ASSEMBLY (w/ Intercooler)

  1. A288732
    Remove the 2 nuts, bolt, No. 1 turbo water pipe and gasket.

  1. Disconnect the No. 1 turbo water hose from the No. 1 turbo water pipe.

← REMOVAL (Jun 2011 – Jul 2012)REMOVAL (from Aug 2013) →