2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.


2. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 4 bolts and cover.


3. DRAIN ENGINE COOLANT

NOTICE:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. A099591E01
    Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.

  1. Loosen the cylinder block drain cock plug and the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.


    A112147E01


4. REMOVE AIR CLEANER ASSEMBLY

  1. w/ Mass Air Flow Meter:

    1. A252009
      Disconnect the mass air flow meter connector and detach the wire harness clamp.

    2. Loosen the hose clamp, and then remove the air cleaner hose from the turbocharger.

    3. Disconnect the ventilation hose and remove the 2 bolts and air cleaner.

  1. w/o Mass Air Flow Meter:

    1. A110353
      Remove the clamp and disconnect the intake air temperature sensor connector.

    2. Loosen the clamp of the turbocharger.

    3. Slide the clamp and disconnect the ventilation hose.

    4. Remove the 2 bolts and air cleaner.


5. DISCONNECT RADIATOR HOSE INLET

6. REMOVE WATER INLET

A097637E01
  1. Remove the 3 bolts and inlet.


7. REMOVE THERMOSTAT
← COMPONENTS (from Aug 2013)REMOVAL (Aug 2012 – Jul 2013) →