2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Aug 2012 – Jul 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.


2. REMOVE INTERCOOLER ASSEMBLY (w/ Intercooler)
(Click here)

3. REMOVE NO. 1 ENGINE UNDER COVER (for 4WD and Pre-Runner)

4. DRAIN ENGINE COOLANT

NOTICE:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. A099591E01
    Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.

  1. Loosen the cylinder block drain cock plug and the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.


    A112147E01


5. REMOVE VENTILATION HOSE HEAT INSULATOR (w/o Intercooler)
  1. Remove the 2 bolts and insulator.


6. REMOVE AIR CLEANER ASSEMBLY

  1. w/ Mass Air Flow Meter:

    1. Disconnect the mass air flow meter connector and detach the wire harness clamp.

      A291271E01

      Text in Illustration 
      *A
      w/ Intercooler
      *B
      w/o Intercooler

    2. Loosen the hose clamp, and then remove the air cleaner hose from the turbocharger.

    3. w/o Intercooler:
      Disconnect the ventilation hose and remove the 2 bolts and air cleaner.

  1. w/o Mass Air Flow Meter:

    1. A110353
      Remove the clamp and disconnect the intake air temperature sensor connector.

    2. Loosen the clamp of the turbocharger.

    3. Slide the clamp and disconnect the ventilation hose.

    4. Remove the 2 bolts and air cleaner.


7. REMOVE VENTILATION PIPE (w/ Intercooler)

  1. A289877
    for Waste Gate Type Turbocharger:
    Remove the bolt and ventilation pipe.

  1. for Variable Nozzle Vane Turbocharger:

    1. A288742
      Disconnect the No. 12 water by-pass hose and No. 13 water by-pass hose.

    2. A288745
      Remove the bolt and ventilation pipe.


8. REMOVE COMPRESSOR INLET ELBOW (w/ Intercooler)

  1. A288737
    Disconnect the 2 connectors and detach the wire harness clamp.

  1. A291249
    Disconnect the No. 1 turbo water hose.

  1. A288735E01
    Disconnect the No. 2 water by-pass hose.
    Text in Illustration 
    *1
    No. 2 Water By-pass Hose
    *2
    No. 13 Water By-pass Hose

  1. Remove the No. 12 water by-pass hose and No. 13 water by-pass hose.

  1. Remove the 2 nuts, compressor inlet elbow and gasket.

  1. A288733E01
    Remove the No. 7 water by-pass hose and No. 12 water by-pass hose.
    Text in Illustration 
    *1
    No. 7 Water By-pass Hose
    *2
    No. 12 Water By-pass Hose


9. DISCONNECT NO. 1 AUTOMATIC TRANSMISSION OIL COOLER TUBE CLAMP (for Automatic Transmission)

A097634E01
  1. Remove the bolt and disconnect the No. 1 automatic transmission oil cooler tube clamp.


10. DISCONNECT RADIATOR HOSE OUTLET
  1. Disconnect the radiator hose outlet from the water inlet.


11. REMOVE WATER INLET

A097637E01
  1. Remove the 3 bolts and water inlet.


12. REMOVE THERMOSTAT
  1. Remove the thermostat from the cylinder block.

  1. Remove the gasket from the thermostat.

← REMOVAL (Jun 2011 – Jul 2012)REMOVAL (from Aug 2013) →