REPLACEMENT
Removal / installation · Vehicles built from Jun 2011
| 1.
REMOVE TIMING GEAR COVER OIL SEAL |
 |
- HINT:
- There are 2 methods to remove the oil seal.
If the timing gear cover is removed from the cylinder block:
- Using a screwdriver and hammer, tap out the oil seal.
- If the timing gear cover is installed to the cylinder block:
Using a knife, cut through the oil seal lip.
Using a screwdriver, pry out the oil seal.
- NOTICE:
- Be careful not to damage the crankshaft.
| 2.
REMOVE TIMING GEAR COVER OIL SEAL |
 |
- HINT:
- There are 2 methods to remove the oil seal.
If the timing gear cover is removed from the cylinder block:
- Using a screwdriver and hammer, tap out the oil seal.
If the timing gear cover is installed to the cylinder block:
- Using SST, remove the oil seal.
- SST
- 09308-10010
09950-40011
(09957-04010)
09950-60010
(09951-00350)
| 3.
REMOVE REAR ENGINE OIL SEAL |
 |
- Using a screwdriver and hammer, tap out the oil seal.
| 4.
INSTALL REAR ENGINE OIL SEAL |
 |
- Using SST and a hammer, tap in a new oil seal until its surface is flush with the rear oil seal retainer edge.
- SST
- 09518-36030
09950-70010
(09951-07100)
Apply MP grease to the oil seal lip.
| 5.
INSTALL TIMING GEAR COVER OIL SEAL |
 |
- HINT:
- There are 2 methods to install the oil seal.
If the timing gear cover is removed from the cylinder block:
- Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing gear cover edge.
- SST
- 09223-15020
09502-12010
09950-70010
(09951-07100)
Apply MP grease to the oil seal lip.
- If the timing gear cover is installed to the cylinder block:
Apply MP grease to the oil seal lip.
Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing gear cover edge.
- SST
- 09223-15020
09502-12010
09950-70010
(09951-07100)
| 6.
INSTALL TIMING GEAR COVER OIL SEAL |
 |
- HINT:
- There are 2 methods to install the oil seal.
If the timing gear cover is removed from the cylinder block:
- Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing gear cover edge.
- SST
- 09214-76011
Apply MP grease to the oil seal lip.
If the timing gear cover is installed to the cylinder block:
Apply MP grease to a new oil seal lip.
- Using SST and a hammer, tap in the oil seal until its surface is flush with the timing gear cover edge.
- SST
- 09214-76011