Install the 2 screws to install the map light assembly.
24.
INSTALL QUARTER INSIDE TRIM BOARD LH
Attach the 4 clips to install the quarter inside trim board.
Connect the rear seat belt shoulder anchor with the bolt.
Torque:
42 N*m{
428 kgf*cm
, 31 ft.*lbf
}
Attach the 2 claws to close the rear seat belt shoulder anchor cover.
25.
INSTALL QUARTER INSIDE TRIM BOARD RH
HINT:
Use the same procedure described for the LH side.
26.
INSTALL LOWER QUARTER TRIM PANEL LH
Attach the 3 clips and claw to install the lower quarter trim panel.
27.
INSTALL LOWER QUARTER TRIM PANEL RH
HINT:
Use the same procedure described for the LH side.
28.
INSTALL UPPER BACK PANEL GARNISH
Attach the 5 clips and 4 claws to install the upper back panel garnish.
29.
INSTALL CENTER PILLAR GARNISH LH
Attach the guide and clip to install the center pillar garnish.
Connect the front seat belt shoulder anchor with the bolt.
Torque:
42 N*m{
428 kgf*cm
, 31 ft.*lbf
}
Attach the 4 claws to install the front seat belt shoulder anchor cover.
30.
INSTALL CENTER PILLAR GARNISH RH
HINT:
Use the same procedure described for the LH side.
31.
INSTALL LOWER CENTER PILLAR GARNISH LH
Attach the 2 clips and 2 claws to install the lower center pillar garnish.
Connect the front seat outer belt floor anchor with the bolt.
Torque:
42 N*m{
428 kgf*cm
, 31 ft.*lbf
}
32.
INSTALL LOWER CENTER PILLAR GARNISH RH
HINT:
Use the same procedure described for the LH side.
33.
INSTALL REAR DOOR OPENING TRIM LH
Align the paint mark on the rear door opening trim with the mark position on the vehicle and install the rear door opening trim as shown in the illustration.
Text in Illustration
*1
Paint Mark
*2
Mark Position
34.
INSTALL REAR DOOR OPENING TRIM RH
HINT:
Use the same procedure described for the LH side.
35.
INSTALL REAR DOOR SCUFF PLATE LH
Attach the 2 clips and 7 claws to install the rear door scuff plate.
36.
INSTALL REAR DOOR SCUFF PLATE RH
HINT:
Use the same procedure described for the LH side.
37.
INSTALL FRONT PILLAR GARNISH LH
w/ Curtain Shield Airbag:
Remove the protective cover.
Attach the 2 guides and 2 clips to install the front pillar garnish.
38.
INSTALL FRONT PILLAR GARNISH RH
HINT:
Use the same procedure described for the LH side.
39.
INSTALL FRONT ASSIST GRIP SUB-ASSEMBLY (w/ Assist Grip)
HINT:
Use the same procedure for both front assist grips.
Align the paint mark on the front door opening trim with the mark position on the vehicle and install the front door opening trim as shown in the illustration.
Text in Illustration
*1
Paint Mark
*2
Mark Position
43.
INSTALL FRONT DOOR OPENING TRIM RH
HINT:
Use the same procedure described for the LH side.
44.
INSTALL FRONT DOOR SCUFF PLATE LH
Attach the 3 clips and 7 claws to install the front door scuff plate.