INSPECTION
Inspection · Vehicles built from Jun 2011
| INSPECT HAZARD WARNING SWITCH ASSEMBLY |
Measure the resistance of the switch.

If the result is not as specified, replace the switch assembly.Standard resistance: Tester Connection
Switch Condition
Specified Condition
2 (E) - 4 (TB)
OFF
10 kΩ or higher
2 (E) - 4 (TB)
ON
Below 1 Ω
Check illumination operation.
Connect the battery's positive (+) lead to terminal 8 and negative (-) lead to terminal 9. Then check that the Bulb illuminates.
- OK:
- Bulb illuminates.
