2014 Hilux · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

HINT:
  1. Use the same procedures for the RH and LH sides.
  2. The procedures listed below are for the LH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY CENTER

  1. for Manual Air Conditioning System:

    1. B278367E01
      Put protective tape around the center instrument cluster finish panel.
      Text in Illustration 
      *1
      Protective Tape

    2. Using a moulding remover, detach the 10 claws and 4 clips.

    3. B278366
      Detach the 4 claws and disconnect the air conditioner control.

    4. Disconnect the connectors and remove the center instrument cluster finish panel.

  1. for Automatic Air Conditioning System:

    1. B278368E01
      Put protective tape around the center instrument cluster finish panel.
      Text in Illustration 
      *1
      Protective Tape

    2. Using a moulding remover, detach the 8 claws and 4 clips.

    3. Disconnect the connectors and remove the center instrument cluster finish panel.


3. REMOVE HEATER CONTROL KNOB

E225817
  1. Remove the heater control knob as shown in the illustration.


4. REMOVE FRE/REC CONTROL KNOB

E225816
  1. Remove the No. 2 heater control knob as shown in the illustration.


5. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY

B113570E01
  1. Detach the 2 claws and remove the switch.

← REMOVAL (Aug 2012 – Jul 2013)INSPECTION (from Jun 2011) →