2014 Hilux · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. INSTALL GENERATOR ROTOR ASSEMBLY
  1. Using a press, press in the rotor.

  1. Place the washer on the rotor.


2. INSTALL GENERATOR RECTIFIER END FRAME

  1. S003959E02
    Using a 17 mm socket wrench and press, slowly press in the rectifier end frame.

  1. A074011E03
    Install the cord clamp and 4 nuts.

    Torque:
    5.9 N*m{ 60 kgf*cm , 53 in.*lbf }


3. INSTALL GENERATOR HOLDER WITH RECTIFIER

  1. A074013E02
    Install the 4 rubber insulators on the lead wires.

    NOTICE:
    Be careful to install the rubber insulators in the correct direction.

  1. A074014E02
    While pushing down on the rectifier holder, install it with the 4 screws.

    Torque:
    2.9 N*m{ 30 kgf*cm , 26 in.*lbf }


4. INSTALL BRUSH HOLDER AND REGULATOR

  1. A074015E01
    Install the regulator with the 3 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }

  1. Install the seal plate.

  1. Install the brush holder with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }

  1. Install the brush holder cover.


5. INSTALL GENERATOR REAR END COVER

  1. A074016E02
    Install the rear end cover and plate terminal with the bolt and 3 nuts.

    Torque:
    4.4 N*m{ 45 kgf*cm , 39 in.*lbf } for nut
    3.9 N*m{ 40 kgf*cm , 35 in.*lbf } for bolt

  1. Install the terminal insulator with the nut.

    Torque:
    4.1 N*m{ 42 kgf*cm , 36 in.*lbf }


6. INSTALL VACUUM PUMP ASSEMBLY
  1. Align the matchmarks and install the vacuum pump with the 4 bolts.

    Torque:
    7.8 N*m{ 80 kgf*cm , 69 in.*lbf }

← INSPECTION (from Jun 2011)INSTALLATION (Jun 2011 – Jul 2012) →