2014 Hilux · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013


1. INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

A112028E01
  1. Using SST, install the sensor to the exhaust manifold.

    SST
    09224-00010  

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf } for use with SST
    44 N*m{ 449 kgf*cm , 32 ft.*lbf } for use without SST

    HINT:
    Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).

  1. Connect the sensor connector.


2. INSTALL AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)

A112026E01
SST
09224-00010  
  1. Using SST, install the sensor to the exhaust manifold.

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf } for use with SST
    44 N*m{ 449 kgf*cm , 32 ft.*lbf } for use without SST

    Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).

  1. Connect the sensor connector.


3. INSTALL V-BANK COVER
  1. Install the cover with the 2 nuts.

    Torque:
    7.5 N*m{ 76.5 kgf*cm , 66 in.*lbf }


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

5. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

← REMOVAL (from Jun 2011)INSTALLATION (Aug 2012 – Jul 2013) →