INSTALLATION
Removal / installation · Vehicles built Aug 2012 – Jul 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
| 1. INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) |
![]() ![]() |
Using SST, install the sensor to the exhaust manifold.
- SST
- 09224-00010
- Torque:
- 40 N*m{ 408 kgf*cm , 30 ft.*lbf } for use with SST
- 44 N*m{ 449 kgf*cm , 32 ft.*lbf } for use without SST
- HINT:
- Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
Connect the sensor connector.
| 2. INSTALL AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1) |
![]() ![]() |
- SST
- 09224-00010
Using SST, install the sensor to the exhaust manifold.
- Torque:
- 40 N*m{ 408 kgf*cm , 30 ft.*lbf } for use with SST
- 44 N*m{ 449 kgf*cm , 32 ft.*lbf } for use without SST
Connect the sensor connector.
| 3. INSTALL V-BANK COVER |
Install the cover with the 2 nuts.
- Torque:
- 7.5 N*m{ 76.5 kgf*cm , 66 in.*lbf }
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. PERFORM INITIALIZATION |
Perform initialization (Click here).
- NOTICE:
- Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.



