2014 Hilux · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Aug 2012

Versions by build date: Jun 2011 – Jul 2012 from Aug 2012

NOTICE:
Do not remove the electric vacuum regulating valve from the bracket.


INSPECT ELECTRIC VACUUM REGULATING VALVE ASSEMBLY (for EGR)
  1. Inspect the electric vacuum regulating valve.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      20°C (68°F)
      11 to 13 Ω
      1 - Body ground
      2 - Body ground
      20°C (68°F)
      10 kΩ or higher

      If the result is not as specified, replace the electric EGR control valve assembly.

  1. A271989E01
    w/ Intercooler:
    Check the operation of the electric vacuum regulating valve.

    1. When a vacuum of 67 kPa (500 mmHg, 19.7 in.Hg) is applied to port F, check that air flows from port E to the filter.

      Text in Illustration 
      *1
      Port E
      *2
      Port F
      *3
      Filter
      *a
      Air
      *b
      Vacuum

    2. A271990E01
      Apply battery voltage across terminals 1 and 2.
      Text in Illustration 
      *1
      Port E
      *2
      Port F
      *a
      Air

    3. Check that air flows from port E to port F.
      If the result is not as specified, replace the electric EGR control valve assembly.

  1. A246396E02
    w/o Intercooler:
    Check the operation of the electric vacuum regulating valve.

    1. When a vacuum of 67 kPa (500 mmHg, 19.7 in.Hg) is applied to port F, check that air flows from port E to the filter.

      Text in Illustration 
      *1
      Port E
      *2
      Port F
      *3
      Filter
      *a
      Air
      *b
      Vacuum

    2. A212980E03
      Apply battery voltage across terminals 1 and 2.
      Text in Illustration 
      *1
      Port E
      *2
      Port F
      *a
      Air

    3. Check that air flows from port E to port F.
      If the result is not as specified, replace the electric EGR control valve assembly.

← INSPECTION (Jun 2011 – Jul 2012)INSTALLATION (Jun 2011 – Jul 2012) →