B15C0 Short in GPS Antenna
Diagnostic trouble codes · Vehicles built from Aug 2013
Also covers:
- B15C1 Open in GPS Antenna
DESCRIPTION
These DTCs are stored when a malfunction occurs in the navigation antenna assembly.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B15C0 |
Navigation antenna error |
|
| B15C1 |
Error of the power source to the navigation antenna |
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK CONNECTION OF NAVIGATION ANTENNA CORD SUB-ASSEMBLY |
Check if the navigation antenna cord sub-assembly is securely connected to the navigation receiver assembly (Click here).
- OK:
- Navigation antenna cord sub-assembly is securely connected.
|
|
||||
| OK | |
| 2. CHECK NAVIGATION ANTENNA CORD SUB-ASSEMBLY |
Disconnect the navigation antenna assembly connector.

Disconnect the GP navigation receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
GP-1 - 1
Always
Below 1 Ω
GP-2 - 2
Always
Below 1 Ω
GP-1 - GP-2 or 1-2
Always
10 kΩ or higher
Text in Illustration *a
Front view of wire harness connector
(to Navigation Receiver Assembly)
*b
Front view of wire harness connector
(to Navigation Antenna Assembly)
|
|
||||
| OK | |
| 3. CHECK NAVIGATION ANTENNA ASSEMBLY |
Replace the navigation antenna assembly with a known good one and check if the same DTC is output again (Click here).
Clear the DTCs (Click here).
Recheck for DTCs and check if the same DTC is output again (Click here).
|
|
||||
| OK | ||
| ||
