2014 Hilux · Service Manual BODY ELECTRICAL

B15A0 LAN Master Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2013

Also covers:

DESCRIPTION

These DTCs are stored when a malfunction occurs in the navigation receiver assembly.
DTC No.
DTC Detection Condition
Trouble Area
B15A0
When either condition below is met:
  1. Bus malfunction
  2. EEPROM error
Navigation receiver assembly
B15AD
When one of the conditions below is met:
  1. A short to ground, short to +B or open occurs in the gyro signal circuit
  2. Gyro sensor malfunction
  3. GPS receiver malfunction
B15B0
Picture circuit (TFT unit) malfunction
B15B3
When one of the conditions below is met:
  1. AM tuner PLL is unlocked
  2. FM tuner PLL is unlocked
  3. Tuner malfunction
B15B4
When one of the conditions below is met:
  1. Mechanism drive signal malfunction
  2. Load/Eject malfunction
  3. Read mechanism malfunction
  4. Mechanical malfunction
B15B7
"Bluetooth" module malfunction

INSPECTION PROCEDURE


1. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTCs are output again (Click here).

    OK:
    No DTCs are output.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)


← B158F AV Signal Stoppage (Low Battery Voltage) (from Aug 2013)B15C0 Short in GPS Antenna (+ B15C1) (from Aug 2013) →