P0560 System Voltage
Diagnostic trouble codes · Vehicles built Jun 2011 – Jul 2012
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The battery supplies electricity to the ECM even when the ignition switch is in the OFF position. This power allows the ECM to store data such as DTC history, freeze frame data and fuel trim values. If the battery voltage falls below a minimum level, the stored ECM data is cleared and the ECM determines that there is a malfunction in the power supply circuit. When the engine is next started, the ECM illuminates the MIL and sets the DTC.| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0560 |
Condition (a) or (b) continues: (a) Significant decrease in battery voltage (b) Open in back-up power source circuit (1 trip detection logic) |
|
- HINT:
- If DTC P0560 appears, the ECM does not store other DTCs.
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).
- HINT:
- Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
| 1. CHECK FUSE (EFI FUSE) |
Remove the EFI fuse from the engine room junction block.

Measure the resistance of the EFI fuse.
- Standard resistance:
- Below 1 Ω
|
|
||||
| OK | |
| 2. INSPECT ECM (BATT VOLTAGE) |
Measure the voltage of the E6 and E7 ECM connectors.

- Standard voltage:
Tester Connection
Specified condition
BATT (E6-2) - E1 (E7-7)
11 to 14 V
|
|
||||
| NG | |
| 3. CHECK HARNESS AND CONNECTOR (ECM - EFI FUSE, EFI FUSE - BATTERY) |
Check the harness and the connector between the EFI fuse and ECM.

Disconnect the E6 ECM connector.
Remove the EFI fuse from the engine room junction block.
Measure the resistance.
- Standard resistance (Check for open):
Tester Connection
Specified Condition
BATT (E6-2) - EFI fuse (2)
Below 1 Ω
- Standard resistance (Check for short):
Tester Connection
Specified Condition
BATT (E6-2) or EFI fuse (2) - Body ground
10 kΩ or higher
Check the harness and the connector between the EFI fuse and battery.
Remove the EFI fuse from the engine room junction block.
Disconnect the positive battery terminal.
Measure the resistance.
- Standard resistance (Check for open):
Tester Connection
Specified Condition
Battery positive terminal - EFI fuse (1)
Below 1 Ω
- Standard resistance (Check for short):
Tester Connection
Specified Condition
Battery positive terminal or EFI fuse (1) - Body ground
10 kΩ or higher
|
|
||||
| OK | |
| 4. INSPECT BATTERY |
Check that the battery is not depleted.
- OK:
- Battery is not depleted
|
|
||||
| OK | ||
| ||
