2014 Hilux · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. REMOVE GENERATOR REAR END COVER

  1. A117269
    Remove the 2 terminal covers by turning them counterclockwise.

  1. A117270
    Using a 15 mm socket wrench, remove the 2 nuts from the end cover.

  1. Remove the screw and end cover.


2. REMOVE GENERATOR REGULATOR SUB-ASSEMBLY WITH BRUSH

  1. A117271
    Remove the 3 screws and regulator.


3. REMOVE GENERATOR STATOR SUB-ASSEMBLY WITH RECTIFIER

  1. A117272
    Remove the 4 screws.

  1. A117273
    Using a screwdriver, pry out the stator.


4. REMOVE FITTING RING

A117274

5. REMOVE GENERATOR PULLEY
  1. Fix the generator in a vise between aluminum plates.

    NOTICE:
    Do not damage the generator.

  1. A197371E01
    Set SST, a ball joint lock nut wrench and an 8 mm bi-hexagon wrench as shown in the illustration.
    SST
    09820-30020  

  1. Hold the 8 mm bi-hexagon wrench in place and turn SST and the ball joint lock nut wrench counterclockwise to loosen the nut.

  1. Remove the nut, washer and generator pulley.


6. REMOVE GENERATOR ROTOR ASSEMBLY

  1. A117276
    Using a press, press out the rotor, and then remove the spacer ring.

← REMOVAL (from Jun 2011)INSPECTION (from Jun 2011) →