2014 Hilux · Service Manual BODY

Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)

Circuit diagnosis · Vehicles built from Jun 2011

DESCRIPTION

If the door glass or the front power window regulator motor assembly (for driver side)*1 or the front door window regulator sub-assembly (for driver side)*2 does not operate smoothly, the jam protection function may be triggered automatically, resulting in the auto up function being unable to fully close the window.
  1. *1: w/o Regulator
  2. *2: w/ Regulator

HINT:
The jam protection function is only available on the driver side power window.


WIRING DIAGRAM

B280492E04

INSPECTION PROCEDURE


1. RESET FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER SIDE) OR FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY (FOR DRIVER SIDE)
  1. w/o Regulator:

    1. Reset the front power window regulator motor assembly (for driver side) (Click here).

  1. w/ Regulator:

    1. Reset the front door window regulator sub-assembly (for driver side) (Click here).

  1. Check that the power window auto up/down function operates normally.

    OK:
    Auto up/down function operates normally.



NG
Go to step 2
OK

END

2. CHECK WINDOW GLASS SLIDING MOVEMENT (APPLICABLE LOCATION)
  1. w/o Regulator:

    1. Remove the front power window regulator motor assembly (for driver side).

  1. w/ Regulator:

    1. Remove the front door window regulator sub-assembly (for driver side).

  1. Install the window glass to the door glass run.

  1. Check if the power window regulator operates smoothly.

  1. Check that the window glass slides smoothly when sliding it up by hand.

    OK:
    Window glass slides smoothly.

    HINT:
    Make sure that the following conditions are met:
    1. The window glass fits with the glass run without improper contact or deformation.
    1. Foreign objects are not caught in the glass run.

    CAUTION:
    w/o Regulator:
    Reset the front power window regulator motor assembly (for driver side) again.
    w/ Regulator:
    Reset the front door window regulator sub-assembly (for driver side) again.

    Result 
    Result
    Proceed to
    OK
    A
    NG (w/o Regulator)
    B
    NG (w/ Regulator)
    C



B
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER SIDE)

C
REPLACE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY (FOR DRIVER SIDE)
A

END (PROBLEM DUE TO RESET FAILURE)


← Power Windows do not Operate at All (from Jun 2011)ON-VEHICLE INSPECTION (from Jun 2011) →