2014 Hilux · Service Manual HEATER & AIR CONDITIONING SYSTEM

Heater Relay Circuit

Circuit diagnosis · Vehicles built Aug 2012 – Jul 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

DESCRIPTION

The heater relay is turned on by signals from the air conditioning amplifier assembly. The heater relay supplies power to the blower motor control.

WIRING DIAGRAM

E225442E02

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. INSPECT HEATER RELAY (HTR)

  1. B106753E01
    Remove the HTR relay from the driver side junction block assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    Battery voltage is not applied to terminals 1 and 2
    Below 1 Ω
    3 - 5
    10 kΩ or higher
    3 - 4
    Battery voltage is applied to terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Below 1 Ω



NG
REPLACE HEATER RELAY (HTR) (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (HTR RELAY - AIR CONDITIONING AMPLIFIER, BATTERY AND BODY GROUND)
  1. Remove the HTR relay from the driver side junction block assembly (Click here).

  1. Disconnect the A44 air conditioning amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    HTR relay terminal 2 - A44-14 (HR)
    Always
    Below 1 Ω
    HTR relay terminal 2 - Body ground
    Always
    10 kΩ or higher
    HTR relay terminal 3 - Body ground
    Always
    10 kΩ or higher
    HTR relay terminal 4 - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    HTR relay terminal 1 - Body ground
    Ignition switch ON
    11 to 14 V
    Ignition switch off
    Below 1 V
    HTR relay terminal 5 - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY

  1. E225456E15
    Remove the air conditioning amplifier assembly with its connectors still connected (Click here).

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A44-14 (HR) - Body ground
    1. Ignition switch off
    2. Blower switch off
    Below 1 V
    1. Ignition switch ON
    2. Blower switch on (LO level)
    Below 1 V
    1. Ignition switch ON
    2. Blower switch off
    11 to 14 V

    Text in Illustration 
    *a
    Component with harness connected
    (Air Conditioning Amplifier Assembly)



NG
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Heater Relay Circuit (Jun 2011 – Jul 2012)Heater Relay Circuit (from Aug 2013) →