PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built Aug 2012 – Jul 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
- HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
| Symptom |
Suspected Area |
See page |
| All functions of the air conditioning system do not operate |
Proceed to "IG Power Source Circuit" |
Click here
|
| Integration panel sub-assembly |
Click here
|
|
| No. 1 cooler wire |
Click here
|
|
| Air conditioning amplifier assembly |
Click here
|
|
| Air Flow Control: No blower operation |
Indicator check |
Click here
|
| Integration panel sub-assembly |
Click here
|
|
| No. 1 cooler wire |
Click here
|
|
| Proceed to "Heater Relay Circuit" |
Click here
|
|
| Proceed to "Blower Motor Circuit" |
Click here
|
|
| Air conditioning amplifier assembly |
Click here
|
|
| Air Flow Control: No blower control |
Indicator check |
Click here
|
| Integration panel sub-assembly |
Click here
|
|
| No. 1 cooler wire |
Click here
|
|
| Proceed to "Blower Motor Circuit" |
Click here
|
|
| Air conditioning amplifier assembly |
Click here
|
|
| Air Flow Control: Insufficient air flow |
Proceed to "Blower Motor Circuit" |
Click here
|
| Temperature Control: No cool air comes out |
Indicator check |
Click here
|
| Integration panel sub-assembly |
Click here
|
|
| No. 1 cooler wire |
Click here
|
|
| Check volume of refrigerant |
Click here
|
|
| Check for refrigerant gas leak |
Click here
|
|
| Proceed to "Pressure Switch Circuit" |
Click here
|
|
| Proceed to "Air Conditioning Compressor Magnetic Clutch Circuit" |
Click here
|
|
| Proceed to "Air Mix Damper Control Servo Motor Circuit (Passenger Side)" |
Click here
|
|
| Proceed to "Ambient Temperature Sensor Circuit" |
Click here
|
|
| Proceed to "Evaporator Temperature Sensor Circuit" |
Click here
|
|
| Proceed to "Room Temperature Sensor Circuit" |
Click here
|
|
| Proceed to "Solar Sensor Circuit" |
Click here
|
|
| Proceed to "Vehicle Speed Signal Circuit" |
Click here
|
|
| Air conditioning amplifier assembly |
Click here
|
|
| Cooler expansion valve |
Click here
|
|
| Temperature Control: No warm air comes out |
Indicator check |
Click here
|
| Integration panel sub-assembly |
Click here
|
|
| No. 1 cooler wire |
Click here
|
|
| Proceed to "Air Mix Damper Control Servo Motor Circuit (Passenger Side)" |
Click here
|
|
| Proceed to "Ambient Temperature Sensor Circuit" |
Click here
|
|
| Proceed to "Evaporator Temperature Sensor Circuit" |
Click here
|
|
| Proceed to "Room Temperature Sensor Circuit" |
Click here
|
|
| Proceed to "Solar Sensor Circuit" |
Click here
|
|
| Proceed to "Engine Coolant Temperature Communication Circuit" |
Click here
|
|
| Proceed to "Vehicle Speed Signal Circuit" |
Click here
|
|
| Air conditioning amplifier assembly |
Click here
|
|
| Heater radiator unit sub-assembly |
Click here
|
|
| Temperature Control: Output air is warmer or cooler than set temperature or response is slow |
Indicator check |
Click here
|
| Integration panel sub-assembly |
Click here
|
|
| No. 1 cooler wire |
Click here
|
|
| Check volume of refrigerant |
Click here
|
|
| Check for refrigerant gas leak |
Click here
|
|
| Proceed to "Pressure Switch Circuit" |
Click here
|
|
| Proceed to "Air Conditioning Compressor Magnetic Clutch Circuit" |
Click here
|
|
| Proceed to "Air Mix Damper Control Servo Motor Circuit (Passenger Side)" |
Click here
|
|
| Proceed to "Ambient Temperature Sensor Circuit" |
Click here
|
|
| Proceed to "Evaporator Temperature Sensor Circuit" |
Click here
|
|
| Proceed to "Room Temperature Sensor Circuit" |
Click here
|
|
| Proceed to "Solar Sensor Circuit" |
Click here
|
|
| Proceed to "Engine Coolant Temperature Communication Circuit" |
Click here
|
|
| Proceed to "Vehicle Speed Signal Circuit" |
Click here
|
|
| Air conditioning amplifier assembly |
Click here
|
|
| Cooler expansion valve |
Click here
|
|
| Heater radiator unit sub-assembly |
Click here
|
|
| Temperature Control: No temperature control (only MAX COOL or MAX WARM) |
Indicator check |
Click here
|
| Integration panel sub-assembly |
Click here
|
|
| No. 1 cooler wire |
Click here
|
|
| Proceed to "Air Mix Damper Control Servo Motor Circuit (Passenger Side)" |
Click here
|
|
| Proceed to "Ambient Temperature Sensor Circuit" |
Click here
|
|
| Proceed to "Evaporator Temperature Sensor Circuit" |
Click here
|
|
| Proceed to "Room Temperature Sensor Circuit" |
Click here
|
|
| Proceed to "Solar Sensor Circuit" |
Click here
|
|
| Proceed to "Vehicle Speed Signal Circuit" |
Click here
|
|
| Air conditioning amplifier assembly |
Click here
|
|
| No air inlet control |
Proceed to "Air Inlet Damper Control Servo Motor Circuit" |
Click here
|
| Air conditioning amplifier assembly |
Click here
|
|
| No air flow mode control |
Proceed to "Air Outlet Damper Control Servo Motor Circuit" |
Click here
|
| Air conditioning amplifier assembly |
Click here
|
|
| Engine idle up does not occur or is continuous |
Proceed to "Air Conditioning Compressor Magnetic Clutch Circuit" |
Click here
|
| Air conditioning amplifier assembly |
Click here
|
|
| Proceed to "SFI System" (for 1GR-FE) |
Click here
|
|
| Proceed to "ECD System (for DPF)" (for 1KD-FTV) |
Click here
|
|
| Proceed to "ECD System (w/ EGR Cooler)" (for 1KD-FTV) |
Click here
|
|
| Proceed to "ECD System (w/o EGR Cooler)" (for 1KD-FTV) |
Click here
|
|
| Proceed to "ECD System (for DPF)" (for 2KD-FTV) |
Click here
|
|
| Proceed to "ECD System (w/ EGR Cooler)" (for 2KD-FTV) |
Click here
|
|
| Proceed to "ECD System (w/o EGR Cooler)" (for 2KD-FTV) |
Click here
|
|
| Proceed to "SFI System" (for 2TR-FE) |
Click here
|
|
| Diagnostic trouble codes are not stored, and set mode is cleared when ignition switch is off |
Proceed to "Back-up Power Source Circuit" |
Click here
|
| Air conditioning amplifier assembly |
Click here
|
| Symptom |
Suspected Area |
See page |
| PTC heater does not function |
Proceed to "PTC Heater Switch Circuit" |
Click here
|
| Proceed to "PTC Heater Circuit" |
Click here
|
|
| Air conditioning amplifier assembly |
Click here
|
|
| Generator assembly (for DENSO Made) [for 1KD-FTV] |
Click here
|
|
| Generator assembly (for BOSCH Made) [for 1KD-FTV] |
Click here
|
|
| Generator assembly (for DENSO Made) [for 2KD-FTV] |
Click here
|
|
| Generator assembly (for BOSCH Made) [for 2KD-FTV] |
Click here
|
|
| Headlight dimmer switch assembly |
Click here
|
|
| Proceed to "ECD System (for DPF)" (for 1KD-FTV) |
Click here
|
|
| Proceed to "ECD System (w/ EGR Cooler)" (for 1KD-FTV) |
Click here
|
|
| Proceed to "ECD System (w/o EGR Cooler)" (for 1KD-FTV) |
Click here
|
|
| Proceed to "ECD System (for DPF)" (for 2KD-FTV) |
Click here
|
|
| Proceed to "ECD System (w/ EGR Cooler)" (for 2KD-FTV) |
Click here
|
|
| Proceed to "ECD System (w/o EGR Cooler)" (for 2KD-FTV) |
Click here
|
|
| Harness and connector |
- |